|
|
|
Kto jest w sklepie?
Sklep przegląda 5428 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
BLOCK DIAGRAM DESCRIPTION
1. Video control and display data Video signal is received from TUNER, AV port(AV1,AV2,S-Video) and goes to the one-chip video decoder (VCTI) which separate the R,G,B signal and passes on the signal to AD converter(AD9883) through the video switch(SM5301). Component signal(YPbPr) from side-jack is also passed to video switch(SM5301) and Micom will select the desired signal(RGB from VCTi or Component from side jack). The AD9883 converts 4:4:4 video format into digital and gives output to the Picture Enhancer (FLI2300).This picture enhancer improves the quality of the picture by changing the level of RGB/YPbPr signals.The output of this enhancer chip is fed to the deinterlacer ,which in turn goes to the Scalar (GM5221).The scalar gives the output on the LVDS cable which is connected to LCD module. VCTi acts a micom and is responsible for video processing and audio signal processing.It accepts the RF precessed signal(IF signal) from tuner/SAW-Filter and separates sound and picture from it. Scaler is reponsible for regulating the timing of signal to LCD panel and size and location of the signal. Graphic control accepts the PC(Analog RGB) and DVI-D (Digital) signal. The signal of PC input is connected to analog port in Scaler and the signal of DVI-D input is connected to digital port. Thus it receives two input and switch between them to give output at the LVDS which in turn gives output at the LCD module. 2. Power The power board supplies a DC voltage of 33V(main power), 24V(Stand_by power), 12V(Stand_by power) to the main board. Main power is only available after power-on and Stand_by is always available. 33V is used by the tuner and 24V is used directly by the inverter and the sound amplifier IC. 24V also is converted into 5V-Main Power and 5V-Stand_by by a DC/DC Converter(MP1593). The 5V is changed into 3.3V and 1.8V by a regulator. Both voltages(3.3V, 1.8V ) is used by VCTI, Scaler, FLI2300 and AD9883. The voltage of LCD Panel is 12V
- 20 -
|
|
|
> |
|
